Carton equipment adjustment should avoid blindness, adjust the position of the main baffle, the left and right baffles and the positions of the upper and lower nail heads according to the carton's rocking cover. It should be noted that the left and right baffles cannot be clamped too tightly, and the cardboard can be smoothly inserted and pulled Out. After the mechanical adjustment is completed, set the touch screen computer: such as carton height = original carton height -40mm, carton nail number, carton nail distance, whether to strengthen nails, etc., single-chip, double-chip selection, etc. After the above work is set, you can start trial production.
If the thickness of the cardboard is too thick, arrange personnel to properly thin the binding site so that the facial paper will not be crushed when binding. The stapling shall be carried out in accordance with the requirements of the production notice. The box nails shall be along the center line of the overlapping part and the deflection shall not exceed 3mm. The nail distance should be even, the distance between the first and tail nails is 20mm above and below the line, the single nail distance is not greater than 55mm, and the double nail distance is not greater than 75mm. It should be fastened firmly, completely through, and there should be no overlapping nails, missing nails, nail twisting, broken nails, bent nails, no corners, etc. The two pieces of box blanks should be aligned, and there should be no scissors mouth.
After ordering is completed, the carton body obtained by folding the carton should be square, and the difference between the two diagonals of the top surface of the carton with an integrated size less than or equal to 1000mm should not be greater than 3mm, and the integrated deviation of the inner diameter of the single corrugated carton is within ± 2mm Within ± 4mm, the difference between the two diagonals of the top surface of the carton with an overall size greater than 1000mm shall not be greater than 5mm, the integrated deviation of the inner diameter of a single-watt carton is not greater than 3mm, and the double-corrugated carton is not greater than 5mm. The hole diameter of the box corner is not more than 4mm2, and there must be no obvious wrap angle, and the outer rocking cover should not be more than 2mm away from the seam or overlap. The nail box shall not have the phenomenon of inverted nails, and the two pieces of box blanks with inconsistent yin and yang surfaces, varieties and specifications shall not be mistakenly ordered together. The ordered carton will be formally produced after passing inspection. When the nail box starts, the servo motor feeds the cardboard, and the nail car motor drives the nail head to complete the nail box. The drive shaft driven by the nail head motor and equipped with a clutch and brake drives the crank mechanism to realize the action of the nail box under the action of the clutch. When the first nail action is completed, the cardboard backboard picks up the cardboard and is operated by the crank mechanism in a stepwise manner The paper feed roller is driven to rotate and stop after reaching a predetermined nail distance, and the second nail action is performed immediately. The key to the nail box machine is the quality of the nail car and the nail head. Product quality failures also occur here.(Double Facer
Auto Splicer
Feeding Wheel)
